I managed to garb a couple of hours this afternoon on the walnut chest. With the glue up gone well, it was time to start fitting the drawer parts. The sides were cut to length and then individually shot into their openings. The aim is for a fit that neither binds nor rattles.
Next the fronts were shot into their respective openings, this fit needs to be very tight.
Next the backs were knifed from the fronts and these were trimmed to exactly the same size.
I then planed up the inside surfaces with my favourite Bill carter plane and applied two coats of melamine Lacquer. Next time I'll be routing the drawer bottoms and cutting the dovetails and through tenons.
No comments:
Post a Comment