Saturday 26 April 2014

Thanks For Watching!


Just over two years ago I thought I'd try posting a video on You Tube to see if it would generate any interest. It has just passed 100,000 views which is better than I could have imagined and has helped generate thousands of orders, particularly to the US.
So as the video says, thanks for watching!

4 comments:

  1. No David. It is we who should be thanking you.

    ReplyDelete
  2. Hi David. Thanks for all of the great videos. Have watched all of the dovetailing ones. I may have missed it but can you tell us what spacing you use, and do you use a half pin at either end?
    Thanks very much.
    Rod

    ReplyDelete
    Replies
    1. Hi Rod, I use half pins at each end and keep the width of the both the pins and half pins at about 2 mm. This is not too skinny but also thin enough to be clearly hand cut. I like to use an odd number of pins which I think gives a better balance. I hop this helps, David.

      Delete
    2. Thanks very much. I'll give it a go!

      Delete